Preparation Before Operation; Place The Remote Controller In The Remote - Daikin FTXG20LV1BW Handbuch

Preparation before Operation

2
Position
–
correctly!
3
1
Remote controller
Screws
Remote
controller holder
NOTE
Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace both old batteries together.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approx. 1 year. If the remote controller display begins to fade and the degradation of reception performance occurs
within a year, however, replace both batteries with new, size AAA.LR03 (alkaline).
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
Notes on remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fl uorescent lamp (such as inverter-type lamps) is in the room. Consult
the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
9
01_EN_3P357704-1.indd 9 01_EN_3P357704-1.indd 9
To set the batteries
+
and 1.
Slide the front cover to take it off.
2.
Set 2 dry batteries AAA.LR03 (alkaline).
3.
Set the front cover as before.
To fi x the remote controller holder on the wall
1.
Choose a place from where the signals
reach the unit.
2.
Fix the holder to a wall, a pillar, or similar
location with the screws procured locally.
3.

Place the remote controller in the remote

controller holder.
To set the luminance of the display
• The luminance of the indoor unit display can be set.
Press
Hi Low
.
Off
12/17/2013 3:21:59 PM 12/17/2013 3:21:59 PM