Preparation Before Operation; Fahrenheit/Celsius Display Switch - Daikin FTX20K2V1B Bedienungsanleitung

Read Before Operation

Preparation Before Operation

1
3
2
Position and
correctly!
Remote controller
Remote
controller holder
Screws
NOTE
Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace both old batteries together.
• The batteries will last for about 1 year. If the remote controller display begins to fade and the possible transmission range becomes shorter
within a year, however, replace both batteries with new, size AAA.LR03 (alkaline).
• The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.
Note on remote controller
• Do not drop the remote controller. Do not get it wet.
9
All manuals and user guides at all-guides.com
To insert the batteries
1.
Remove the back cover by sliding and then
slightly lifting it.
2.
Insert 2 dry batteries AAA.LR03 (alkaline).
3.
Replace the back cover.
To fi x the remote controller holder to a wall
1.
Choose a place where the signals reach the
unit.
2.
Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the holder.
3.
Hang the remote controller on the remote
controller holder.

Fahrenheit/Celsius display switch

Press and
simultaneously for about 5 seconds.
• The temperature will be displayed in Celsius when it is presently displayed in
Fahrenheit, and vice versa.
• The switch operation is only possible when the temperature is being displayed.
Turn on the circuit breaker
• After the power is turned on, the fl ap of the indoor unit opens and closes once to set the
reference position.
(TIMER button)