Texas SP 50 Bedienungsanleitung Seite 21

Pump the primer (B) according to the scheme below :
Pull the handle (B) up to activate the self-propelling function.
Pull the handle (A), which loosens the knife brake, towards the handle and pull the
starting cord. Let the starting cord carefully return to the engine.
The handle (A) must be pulled towards the steering handle while using the machine.
When the handle is released, the engine (and the knife) stops in 5 seconds.
Temperature
> 0° C
> 0° - 10° C
> 10° - 20° C
> 20° C
Oil change
The oil must be changed after the first 5 hours of use. After that the oil must be changed at
least once a year.
1. Let the engine run for 5 minutes to warm up the oil. This makes it run easier and
make the oil change more complete.
2. Turn off the engine after 5 minutes. Take off the spark plug cap. Unscrew the
cork for the drain plug. Theo oil now runs out of the engine. Keep a suitable
container ready to collect the oil.
NOTE that the engine may only be tilted backward at an angle of max 45
degrees.
Refit the drain plug and pour fresh oil into the engine.
3. This is done by removing the oil stick and filling with correct amount of oil.
4. Mount the spark plug cap.
A
B
Push
2-3
1-2
0-1
0
21
B