Victron energy BPP2 Anleitung Seite 32

PowerAssist
Boost factor
AES
Start AES below
Stop AES above
AES type
Charger settings menu
Enable charger
Weak AC input
Stop after 10 hr
Battery type
Storage mode
Use TPTB curve
Charging chars
Absorption voltage
Float voltage
Charge current
Rep abs time
Rep abs interval
Max abs time
VVC menu
†Device name
26
Setting If enabled, the inverter will start up if the
current consumption becomes too high, to
prevent tripping the external breaker.
Setting Used to calculate the required current during
PowerAssist.
Setting Reduces the current drawn when the inverter
load is low, but can take more time to switch to
full load.
Setting When power consumption drops below this
point AES will be activated if it is enabled.
Setting AES mode will be deactivated if power
consumption rises above this level.
Setting Selects the waveform type to be used during
AES operation.
Setting Switch the charger on or off.
Setting Enable this setting if poor A.C. input causes
charging problems.
Setting Enable this setting to prevent overcharging
damaged batteries. Disable this setting if your
battery requires a bulk period of more than 10
hours.
Setting Select the type of battery that is connected.
Setting Enable this setting to use a voltage set point of
13.2 V (for a 12 V system); otherwise the
normal float voltage will be used.
Setting Use the tubular plate traction battery charging
curve.
Setting Select which charging algorithm should be
used.
Setting Specify the absorption voltage to be used
when charging.
Setting Specify the float voltage to be used when
charging.
Setting The amount of current used to charge the
battery.
Setting Specify the duration of repeated absorption
pulses.
Setting Specify the interval between repeated
absorptions
Setting Specify the maximum period of time the
absorption phase should last.
Setting The name that will appear in the VPN's device
list.