Using An Extension Cable; Protecting The Environment - DeWalt DE9116 Bedienungsanleitung

EN GLI SH
In case the mains connection line of this unit
should be damaged, it must be replaced by the
manufacturer, after-sales service or similar qualified
and/or authorized persons.
Your D WALT charger is double insulated in
E
accordance with EN 60335; therefore no
earth wire is required.
Mains Plug Replacement
(U.K. & Ireland only)
DANGER:
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 3 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their respective
points in the plug (see below). Brown is for Live
(L) (2) and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
4
3
WARNING: Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or

Using an Extension Cable

If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data).
22
The minimum conductor size is 1.5 mm
using a cable reel, always unwind the cable
completely.
Also refer to the table below.
Conductor size (mm
0.75
1.00
1.50
2.50
4.00
Cable length (m)
Voltage Amperes
230 0 – 2.0
2.1 – 3.4
3.5 – 5.0
5.1 – 7.0
7.1 – 12.0
12.1 – 20.0
MAINTENANCE
This product is not user serviceable. There are no
user serviceable parts inside the charger. Servicing
at an authorized service center is required to avoid
damage to static sensitive internal components.
Your D WALT charger has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper care and regular cleaning.
1 Cleaning
2
WARNING:
• Unplug the charger before cleaning the
housing with a soft cloth.
• Keep the ventilation slots clear and
regularly clean the housing with a soft
cloth

Protecting the Environment

Separate collection. This product must
.
not be disposed of with normal
household waste.
. When
2
) Cable rating (Amperes)
2
6
10
15
20
25
7.5 15 25 30 45 60
Cable rating (Amperes)
6 6 6 6 6 6
6 6 6 6 6 6
6 6 6 6 10 15
10 10 10 10 15 15
15 15 15 15 20 20
20 20 20 20 25 –