Torque Calibration - Desoutter ELB2.5-1250-P Bedienungsanleitung

6159933730_27
BRIEF DESCRIPTION
A
See page 15.
Legend
1 Ventilator slots
2 Reporting bar
3 Torque calibration opening
4 Ring
5 High-intensity LED
6 Trigger
7 To remove the battery pack
8 Battery pack
9 Reverse button
● Exact and quick torque cut-off with an audible
click.
● Ergonomically shaped handle to reduce
fatigue.
● Control light, informing on the screw fixing and
the state of the battery.
● Bit reception with a quick exchange function.
● Comfortable trigger for screw tightening and
reverse mode operation.
● Powerful battery pack attachable in two ways,
either for a compact shape of the battery
screwdriver or for an optimum balance.
ASSEMBLY AND DISASSEMBLY
Follow standard engineering practices and
refer to figure for the mounting of component
subassemblies.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
Please contact your "Customer Centre"
or consult the website
"www.desouttertools.com" to find out
where you can recycle this product.
INSERTION OF THE BATTERY PACK
B
See page 8.
Legend
B1 Balanced
B2 Compact
The battery screwdriver is ready to operate as
soon as a loaded battery is mounted on the tool.
There is no On/Off switch.
REMOVING THE BATTERY PACK
C
See page 8.
HOW TO START THE TOOL
D
See page 9.
Any time the trigger is pressed, the high-intensity
LED will light.

TORQUE CALIBRATION

E
See page 9.
The tool has a tamper proofed calibration: a
black cover protects the clutch mechanism from
unvolontary action.
For safety reasons, always remove
the battery before proceeding with
the calibration.
1. Turn the bright screw 90° and the black cover
will open and the clutch will be visible.
2. Use the clutch adjustment key to turn the
clutch to the position where the adjustment
hole is visible.
3. Use the clutch adjustment key to increase or
reduce the torque ("+" and "-" appear on the
calibration tool).
4. Close the cover again.
EXCHANGING SCREWDRIVER BITS *
F
See page 9.
* According model.
The new bit is automatically locked when
you release the ring.
NOW THE TOOL IS READY FOR
TIGHTENING
Start tightening
G
See page 10.
After each tightening, the battery screwdriver
displays result information.
IMPORTANT: No result information is
displayed when operating in the reverse
mode.
Rehit protection
H
See page 10.
If the tool should be applied to an already
tightened screw, the clutch immediately operates
and there will be no significant tightening angle.
BUZZER
Disable
I
See page 10.
Enable
J
See page 10.
REVERSE ACTIVATION
K
See page 11.
18 / 134
English
10/2019