Operation - AKO -52044 Bedienungsanleitung

8.- Operation

-In all of the examples shown, the password printed on the alarm label is used by default.
If you have changed it, remember to replace it with the current password.
WARNINGS:
-In the configuration, confirmation, and tracking messages, use commas (,) only to separate the different
parameters, never to define alert messages.
-The only purpose of the blank spaces is to define alert messages.
-Messages can be entered in capital or lower-case letters, whichever is acceptable.
-Pay special attention to your mobile telephone's spell check function. Check that the message is correct
before sending it.
-We recommend you do not use accents.
-We recommend that you use the application "AKO SMS" for Android smartphones to carry out
the configuration. This is available on the page www.ako.com and in the Google Play Store.
Alarm sending sequence
When an alarm is detected in any of the inputs, the alarm sends an SMS to the assigned contacts in the following
order:
Tel.
Tel.
If the first number does not send a confirmation message in the preset time (response time), the alert is sent to
the next number, and so on. If the last number on the list does not answer, the system will start again with the first
one.
When a confirmation message is sent, there are no more notifications of the alarm until it disappears and is re-
activated.
The alarm message is configurable (see page 20). If it has not been changed, the received message will be similar
to the following:
ALARM,I4,ALARMA IN 4
Alarm confirmation
To confirm an alarm, reply to the message received with OK I<input number>. You do not have to enter the
administrator password; the alarm will respond with a confirmation message after a few moments.
Example:
After a few seconds, the alarm responds with the message*:
OK
*If you receive an error message, refer to page 25.
Tel.
1 2
Tel.
10 9
Tel. Tel.
3 4
Tel. Tel.
8 7
OK I4
21
5204H401 Ed.01
Tel.
5
Tel.
6
Send