AKO -52044 Bedienungsanleitung Seite 24

Status query
To query the unit status at any time, send "STATUS".
Send "STATUS"
After a few moments, the alarm responds with a message similar to this one*:
INPUT1: NO ALARM INPUT2: ALARM
INPUT3: NO ALARM INPUT4: NO ALARM
OUTPUT1; OFF OUTPUT2: OFF
BATTERY: OFF
SIGNAL STRENGTH: -65 dBm
TIME: 2016/03/17 11:17:40
INPUTx
OUTPUTx
BATTERY
SIGNAL STRENGTH
Telephone number query
The alarm returns the telephone number from which it received the message. This allows you to confirm the format
in which the alarm receives the telephone number so that you can configure the telephone list correctly (avoiding
international prefixes, short codes, etc.).
Send "MYPHONE"
After a few moments, the alarm sends a response similar to this one*:
MY PHONE IS: 609111111
Version query
The alarm informs you of the version of software that is installed. This information is necessary if you need to
consult our technical service.
Send "VERSION"
After a few moments, the alarm responds with*:
Firmware version 0.9
*If you receive an error message, refer to page 25.
ALARM: Active alarm in the indicated input
NO ALARM: Inactive alarm in the indicated input
OFF: Inactive relay in the indicated output
ON: Active relay in the indicated output
OFF: Unit operating with power supply at 230 V
ON: No power supply at 230 V, unit working on battery power
Indicates the strength of the signal received:
> -101 dBm =
Between -99 and -91 dBm =
Between -89 and -81 dBm =
Between -79 and -65 dBm =
< -65 dBm =
24
STATUS
Send
MYPHONE
Send
VERSION
Send
5204H401 Ed.01