AKO -52044 Bedienungsanleitung Seite 20

Input configuration
Allows you to configure the behaviour of the digital inputs.
Send "I(n), <NC/NO>, <persistence time>, <message>"
Number of the input to be configured.
<n>
Defines the input polarity:
<NC/NO>
Time in seconds that the input must remain active to send an alert.
<persist. t.>
Message that will be received if the alarm for the configured input is activated.
<message>
Example: To configure input 2 as a normally open contact, with a persistence time of 15 seconds and a
customised alert message, send:
After a few seconds, the alarm responds with the message*:
I2 OK
Customisation of power failure message
Change the alert message for power failure or restoration of power.
Send "BATMSG,<message OFF>,<message ON>
message Message in the event of power failure
< OFF>
message Message in the event of power being restored
< ON>
Example: Send:
After a few seconds, the alarm responds with the message*:
BATMSG OK
Customisation of the reset message
Change the alert message for the alarm reset. This message is sent only to the first number on the
telephone list.
Example: Send "RESETMSG, <message>
After a few seconds, the alarm responds with the message*:
RESETMSG OK
*If you receive an error message, refer to page 25.
NO: Normally open, the alarm is activated on closing.
NC: Normally closed, the alarm is activated on opening.
I2,NO,15,High temperature
in frozen food cold room
BATMSG,Power failure,
Power has been restored
RESETMSG, The alarm has been reset
20
5204H401 Ed.01
Send
Send
Send