AKO -52044 Bedienungsanleitung Seite 22

Control of relays
You can activate or deactivate the output relays at will, by sending SMS messages, which allows you to remotely
act on the facility.
To change the status of the relays, send "RELES, <Relay 1 status>, <Relay 2 status>".
Relay statuses:
Example: To activate relay 1 and deactivate relay 2, send:
After a few seconds, the alarm responds with the message*:
RELE 1: ON
RELE 2: OFF
Power failure alert message
If a power failure occurs, the alarm starts to operate in battery mode and sends an alert message to the
administrator.
POWER OFF (BATTERY ON)
If the battery runs out, the active relays are deactivated and remain deactivated even when the power is restored.
When power is restored, the alarm will send an alert message to the administrator.
The alert message is customisable in both cases (see pg. 20).
POWER ON (BATTERY OFF)
Reset alert
If the unit is restarted, whether it is because of a power failure or a forced restart using the reset button, the alarm
sends a customised message (see pg. 20) to the first telephone number on the list. If you have not customised the
message, the alert will not be sent.
Reset function
The alarm has two types of reset:
-Partial reset. Press the reset button for less than 5 seconds: the alarm is
reset and it keeps the current configuration.
-Total reset. Press the reset button for more than 5 seconds: the alarm is
reset and returns to the factory settings, including the password. (All of the
LEDs turn on and off 3 times).
*If you receive an error message, refer to page 25.
0 OFF 1
22
ON
RELES,1,0
5204H401 Ed.01
Send