Installation - AKO -52044 Bedienungsanleitung

5.-

Installation

Fig. 1a
4 8 m m
Figure 2
2
2
1
IMPORTANT: Before starting to install the alarm, check that there is enough coverage in the installation
place.
-Open the SIM card cover at the back of the unit and install the SIM card (Fig. 2). Remember that the PIN must
be disabled.
-Assemble the supplied antenna (figura 3).
-Remove the connections cover (C) and the main cover (A) by inserting a screwdriver into each of the 4 slots and
turning it by 90º (figures 1a and 1b).
-Connect the battery (Figure 4) and check that the coverage LED lights up green after a few seconds.
-Mark and drill the 2 fastening holes of the box on wall according to Figure 1.
-Close the main cover (A).
-Affix the alarm to the wall using two screws (B) and 2 plugs (not included).
-Make the wiring connections according to the diagram on page 6. The terminal strips can be detached to make
wiring easier (Figure 5).
-Close the cover (C).
Figure 1
Figure 3
3
1
17
A
Fig. 1b
B
C
Figure 4
5204H401 Ed.01
Figure 5