Operation - AKO -52042 Bedienungsanleitung

5.- Operation

The default password is used in all the examples shown. If you have changed it, remember to replace it
with the current password.
WARNINGS:
-In the configuration, confirmation, and tracking messages, use commas (,) only to separate the different
parameters, never to define alert messages. The only purpose of the blank spaces is to define alert
messages.
-Messages can be entered in capital or lower-case letters, whichever is acceptable.
-Pay special attention to your mobile telephone's spell check function. Check that the message is correct
before sending it.
Alarm sending sequence
When an alarm is detected in any of the inputs, the alarm sends an SMS to the assigned contacts in the following
order:
If the first number does not send a confirmation message in the preset time (confirmation time), the alert is sent to
the next number, and so on. If the last number on the list does not answer, the system will start again with the first one.
When the confirmation message is sent, the incident should be solved within the time set in "Resolution time";
if after this time the input continues to be active, the sending sequence will start again from the beginning.
The alarm message is configurable (see page 20), if it has not been changed, the message received will be:
Alarm confirmation
To confirm a received alarm, answer the message received with an OK. You do not have to enter the administrator
password, the alarm will respond with a confirmation message after a while.
Example:
After a few seconds, the alarm responds with the message:
Tel. Tel.
1 2
Tel. Tel.
10 9
alarma entrada x
OK
Tel. Tel.
3 4
Tel. Tel.
8 7
OK
Send
15
Tel.
5
Tel.
6