Installation - AKO -52042 Bedienungsanleitung

6.- Installation

Figure 1
Figure 3
1
2
3
IMPORTANT: Before starting to install the alarm, check that there is enough coverage in the installation place.
It should be installed so that the antenna is at the top part, as shown in figure 1.
-Mark and drill the 4 fastening holes of the
-Remove the cover (A) and affix the alarm to the wall with four 4x40 (B) screws + four 6 mm plugs (Not included).
-Install the SIM card (fig. 3), remember that the PI
-Assemble the supplied antenna (fig. 4).
-Make the connections according to the diagram on page 18, passing the cables through the glands. End
tightening the glands. If one of the glands is not used, it must have the supplied red cap installed (fig. 5).
-Connect the battery (fig. 6) and check that the operation and battery charging LEDs are on and that the coverage
LED flashes every 3 seconds.
-Close the cover (A).
Figure 4
box on wall according to figure 2.
N must be disabled.
B
A
Figure 2
Figure 5
17
113
181
Figure 6