Troubleshooting - Walo Professional S-BP40 Installations-, Gebrauchs- Und Wartungsanleitung

THE DISHWASHER
NOT WASH WELL
THE GLASSWARE
DISHES ARE NOT DRY
CONDENSATE ON
GLASSWARE
SPOTS ON THE GLASSWARE
EXCESSIVE PRESENCE OF
FOAM IN THE BASIN
GLASSWARE STREAKED OR
SPOTTED
Cod.W010212

4. TROUBLESHOOTING

DOES Check if the intake filter is dirty and clean it thoroughly.
7.
Check that the washing jets are not obstructed by solid residue
8.
Check that the quantity of the initial detergent and/or the additions
9.
during the washing cycle are correct.
The selected washing cycle is too short. Repeat the cycle.
10.
Check that the basin temperature is between 50°C and 65°C.
11.
Check that the dishes are positioned correctly in the baskets.
12.
AND Check the instructions for the amount of rinse aid (see paragraph
4.
"dispenser adjustment"). Check that there is rinse aid in the
container and fill it up if necessary.
Check the quantity of rinse aid used (see paragraph "dispenser
5.
adjustment").
Check that the temperature of the rinsing water is between 80°C
6.
and 90°C.
THE
Check that there is rinse aid in the container and fill it up if
4.
necessary.
Check the quantity of rinse aid used (see paragraph "dispenser
5.
adjustment").
Remove the basket with the glassware immediately after the cycle
6.
has ended
Use only "non foaming" products for professional dishwashers
2.
Check that the washing water temperature is not lower than 50°C.
5.
Check if the detergent dispenser releases too much product (see
6.
paragraph "dispenser adjustment").
Make sure that the basin was cleaned with suitable detergents.
7.
If a foaming detergent was used, refill the basin with water until the
8.
foam has disappeared.
2. Reduce the amount of rinse aid (see paragraph "dispenser
adjustment").
Pag.42 09/05/2017