Drain Pump (Optional) - Walo Professional S-BP40 Installations-, Gebrauchs- Und Wartungsanleitung

Close the door and press the drain button
Wait for the sanitizing cycle for a few minutes,
until the middle of the dashboard displays green
light indicating the end of the cycle.

Turn off the dishwasher with the "
button
WARNING !! (cleaning the outer surfaces)
Before starting with
disconnect the equipment's electric power supply
located on the electric panel, remembering that
the machine remains powered when only the
switch on the control panel is turned off.
WARNING !! (cleaning the outer surfaces)
Wash the stainless steel surfaces with warm
soapy water, avoiding the use of detergents that
contain abrasive substances, scourers, brushers
or steel scrapers, then rinse with a wet cloth and
dry carefully.
Clean the control panel with a soft cloth
moistened with water and, if necessary, neutral
detergent.
Do not wash the equipment with direct or high
pressure jets of water.
Cod.W010212
"
on / off
cleaning operations,
WARNING !! (cleaning the outer surfaces)
The equipment must not be cleaned with water
jets.
In order to reduce the release of polluting
substances to
recommended to clean the equipment with
products that have a level of biodegradability
above 90%.
Leave the door open for the entire period the
machine will not be used.

3.5 DRAIN PUMP (optional)

On request, it is possible to install a drain pump to
facilitate the emptying operations in the event that
the drain siphon is positioned higher than the
basin level.
This should be done by qualified personnel,
trained and responsible for the modification.
d) Make sure to disconnect the power
switch.
e) The connections inside the board are
already prepared to operationalize the
drain button (see figure below).
f) Unscrew the 2 fixing screws and remove
the lower door to access the inside of the
base.
d) Connect the wiring set up for the drain
pump inside the base and close the lower
door by tightening the 2 screws.
Pag.39
the environment,
09/05/2017
it is