Maintenance - Walo Professional S-BP40 Installations-, Gebrauchs- Und Wartungsanleitung

Press the parameters scroll buttons to find the
control parameter of the rinse aid: button "III"
back, drain button forward until the following
appears on display: "ri" on the rh, and the
seconds set by default on the lh.
R i
press the "II" button to increase (+) press the "I"
button to decrease (-) the assigned default value
of 25 seconds.
R i
once the parameter is modified, press (OK) to
confirm, as shown in the figure below.
R i
the same procedure adopted for the rinse aid
should be performed to change the control
parameter of the detergent, until the following
appears on the display: "De" on the lh, and the
seconds set by default on the rh (12).
to exit the parameter menu, press the button
"on/off" in the figure below for a few seconds
Suggestion: to check the effectiveness of the
rinse aid, look at glasses that were just washed up
against the light. Drops of water on the glass
indicate that the amount is not sufficient, streaks
indicate an excessive amount.
Replacing the type of detergent and rinse aid:
If the type of detergent/rinse aid is being changed,
even if it is the same brand, the intake and
delivery pipes must be rinsed with clean water
before connecting the new detergent/rinse aid
container. Otherwise,
different types of detergent/rinse aid could cause
crystallization, possibly causing the dispensing
Cod.W010212
25
25
30
the mixture between
pump to break.
requirement will void the warranty and liability of
the manufacturer.
RECOMMENDATIONS:
To get an indication on the quality of
the product for the first calibration,
refer to the doses indicated by the
supplier of the selected product.
The adjustment should be refined by
evaluating
obtained after at least three cycles to
stabilize the results.
In the basin, there must be no foam at
the end of the cycle, if there is, check
the temperature of the basin or reduce
the dose of rinse aid.

MAINTENANCE


Once or twice a year, descale the boiler, the
inner surfaces of the basin and the machine
pipes.

Each month, descale the rinsing and washing
jets in a bath of vinegar or descaling agent.

The tube inside the peristaltic rinse aid and
detergent dispenser must be subjected to
periodical maintenance (once or twice a year).
Prolonged period of inactivity
If dishwashers remain unused for a long period of
time, proceed as follows:

Close the supply water cock.

Completely empty the basin

Remove and clean the filter carefully

Completely empty the built-in dispenser
tubes, removing the tubes from the cans.
Repeatedly
described
manual
detergent/rinse aid is emptied.

Spread a layer of Vaseline oil on all the
steel surfaces.

It is recommended to call a qualified
technician to perform a general check of
the equipment when it is not used for a
considerable period of time.
Pag.34
Failure to observe
the washing
repeat the procedures
in paragraph 2.4
activation until the
09/05/2017
this
results
section
liquid