Integrated Softener Setting; Automatic Regeneration And Integrated Softner Manual - Walo Professional S-BP40 Installations-, Gebrauchs- Und Wartungsanleitung

3.6 INTEGRATED SOFTENER SETTING

The integrated softener assures the production of
softened water for each rinse cycle. This warranty
essentially depends on the water hardness
expressed in French degrees [F] or in German
degrees [D].
The table below shows the amount of treated
water according to the water's hardness.
Incoming water
hardness
20°F / 11°D
30°F / 17°D
35°F / 19.5°D
40°F / 22.5°D
50°F / 28°D
Dividing the average quantity of treated water,
with the litres of each individual rinse (3 lt) we can
automatically determine the point of regeneration,
taking a lead from the table below:
Average quantity of
treated H2O
260 lt.
170 lt.
130 lt.
110 lt.
90 lt.
Instruct specialists to check the water hardness
before using the machine.
Once the hardness of the water is verified you can
make the setting of the " softened cycles" through
the dashboard.
To enter in the configuration mode simultaneously
press the below depicted buttons for several
seconds.
Co
Press the buttons for the parameters scroll to
search for the control's parameter of the softened
cycles: button "III" back, drain button go ahead
until appears on the display the following: on the
left "rN" and on the right the default set cycles.
Cod.W010212
Average quantity of
treated H2O
260 lt.
170 lt.
130 lt.
110 lt.
90 lt.
Useful rinse
cycles
86
56
43
36
30
Nf
Press the button "II" to increase (+) press the
button "I" to decrease (-) the value.
After you have modified the parameter press the
button of confirmation (OK) as shown below.
To exit the parameters menu press for a few
seconds the "on/off" button shown in the figure
below.
3.7 AUTOMATIC REGENERATION AND
INTEGRATED SOFTNER MANUAL
When the programmed count-down of the useful
cycles has completed its count, it starts to flesh
the LED "OK"
RIGENERAZIONE AUTOMATICA
The automatic regeneration starts as soon as the
useful cycles are finished, and it happens both
with the machine in stand-by and the washing
cycle in function. With the regeneration in
progress and the machine in stand-by mode you
can start any washing cycle without jeopardise the
orderly functioning.
In some cases, if the automatic regeneration
doesn't end before the washing process in
function, the washing cycle continues until the end
of the regeneration, continuing then with the
rinsing process.
Pag.40
rN
86
rN
43
rg
43
09/05/2017