Lack Of Salt Alarm - Walo Professional S-BP40 Installations-, Gebrauchs- Und Wartungsanleitung

In case of simultaneous start of washing and
regeneration, the prolongation of the washing
cycle doesn't exceed 2 minutes of waiting.
During the regeneration process, the OK button's
LED stays STEADY enlightened, thus informing
the customer that the prolongation of the washing
is due to the regeneration process in function.
MANUAL REGENERATION
In the event that the user wishes to regenerate the
softeners before the end of the count-down, this is
possible by pressing the button OK of the control
panel.
The regeneration can be activated in any type of
service, if you were to start a washing cycle during
the regeneration in function, it is completed
without any extension of time.

3.8 LACK OF SALT ALARM

On the control panel is expected a light that
shows that the brine is not ready for lack of salt.
Check and fill the container of salt for ¾ of its
volume, wait about 30 minutes before the brine
formation, and at that point the warning light turns
off.
Cod.W010212 Pag.41 09/05/2017