Other; Batteries Instructions (Fig. 9); How To Use The Remote Controller Correctly; Overheat Protection Of The Motor - Beko EFS8000W Bedienungsanleitung

6

Other

6.1 Batteries instructions (Fig. 9)

Batteries should be installed before using the remote control. It uses a 3 -volt button battery.
1. Open the battery cover;
2. Install a new battery, pay attention to the battery polarity (+ and -);
3. Close the battery cover.

6.2 How to use the remote controller correctly

1. The remoter controller must point to the receiving window of the fan when it is used;
2. The remoter controller can be normally used within five meters and 30 degrees from the fan;
3. Avoid direct sunlight on the receiving window, so as not to affect the receiver' s effect;
4. Remove the built-in batteries when do not use the remote control for a long time or before the
batteries are leaked.

6.3 Overheat protection of the motor

The windings of the motor have a thermal-fuse that burns out and the fan switches off and
temperature of the motor is no longer going up so that plastic parts of the fan don't subject to
deformation so far so to be burned by the overheat if the motor is overheat for any unexpected
reason.

6.4 Maintenance instructions

The fan requires little maintenance. Do not try to fix it by yourself. Refer it to qualified service
personnel if service is needed.
1. Before cleaning and assembling, fan must be unplugged.
2. To ensure adequate air circulation to the motor, keep vents at the rear of the motor free of dust. Do
not disassemble the fan to remove dust.
3. Please wipe the exterior parts with a soft cloth soaking a mild detergent.
4. Do not use any abrasive detergent or solvents to avoid scratching the surface. Do not use any of the
following as a cleaner: gasoline, thinner.
5. Do not allow water or any other liquid into the motor housing or interior parts.

6.5 Cleaning

1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with a soft cloth moisten with mild soap. Thoroughly remove soap
film with dry cloth.
Stand Fan / User Manual
13 / 16 EN