Control Panel (Fig. 10) - Beko EFS8000W Bedienungsanleitung

5 Operating instructions
If the temperature is lower than 20°C, the fan will stop working. If the temperature is higher than 20°C,
the fan will work again. When you choice comfortable wind, the icon "
display "00".
Silence: Press this key to make the fan switch to the mute mode, in which the noise is low and the
mute indicator " " will be on. Press this key again, the fan will switch to the normal air mode and work
at the low speed.
" " OSC key
After the fan starts, repeatedly touch this button to start or stop oscillation.
" " PRO key
Under power-on state, timed power-off can be set. Press the PRO button; it starts the timing power-
off state. "Timing" and icon displayed on the fan display will flash once per second, the rotate the drive
plate clockwise, the fan display will display 0.5 → 1.0 → ...... → 12.0 → 00 → 0.5 → ...... in cycle, rotate
the drive plate counterclockwise, it cycles as 7.5 → ...... → 0.5 → 00 → 12.0 → .......
When set a time, 5 seconds without any operation, the timing on the display flashes twice and beep to
refer successfully settings, if there is any button operation in five seconds (except for on/off button),
the time is successfully set and the fan returns to current state immediately, "Timing" and icon stops
flashing, if the timing button is pressed in five seconds then timing is cancelled. If there is time setting,
then "Timing" and icon is lit, if not, it is off. When setup is successful, the display returns to display the
wind level.
Under standby mode, press the PRO button to set power-on time, "PRO" and icon is lit, the operation
mode please refers to timed power-off; rotate the drive plate to adjust the time. After adjustment, the
set time will be displayed on the screen. To cancel a time setting, user only need to repeatedly press
the PRO button.
Inquiry: Under working state, press forward/timing button to enter the timing status, user can check
the set time, and user can re-set the time in five seconds; if no operation within five seconds, the time
shown on the screen flashes twice and returned to the wind level.

5.2 Control panel (Fig. 10)

• O n/Off button
Same as them on remote control.
• F unction button
1. Under working state, short press the function button, the fan will alternate between oscillation
and fix; Long press the button, the fan enters into the timing function, refer to the operating
instructions of PRO button on remote control (To cancel the timer, long press function button).
2. Under standby mode, short press of the function button is invalid; Long press the function button,
the fan enters into the appointment starting function, refer to the operating instructions of PRO
button on remote control (To cancel the timer, long press function button).
10 / 16 EN
" will be lighted and the IDM
Stand Fan / User Manual