How To Fill And Empty The Tank; Water Level - Abilica AtlanticRower NS-RE6006 Bedienungsanleitung

HOW TO FILL AND EMPTY THE TANK

1. Remove the fill plug (24) from the upper tank (17).
2. Refer to the A illustration to fill it with water. Insert the funnel (106) into the
tank. Use a water cup or the syphon pump (105) and a bucket to fill the tank.
Use a water level gauge on the side of the tank to measure desired water level
(volume) in the tank.
3. Refer to the picture B to empty the tank. Place a bucket next to the rower. Use
the syphon pump (105) to pump out the water from the tank into the bucket.
4. Once completed, insert the fill plug (24) into the upper tank (17). Wipe excess
water out from the frame after filling.
NOTE
:
 Fill the tank only with tap water. We strongly recommend you to purchase water-
purification tablets. Use 1 tablet in the tank each 6 months. Never use pool
chlorine or chlorine bleach. This will damage the tank and void the warranty.

WATER LEVEL

 See Fig. A. The water level gauge is on the side of the tank. The maximum fill
level is 10. Never fill it over this limit. Filling the tank over this limit will void the
warranty.
 The resistance depends on the water level in the tank. Water level 1 is the
lowest resistance. Level 9 is the highest resistance.
12