Sanus LF228 Montageanleitung Seite 8

2
Mount the Wall Plate
2-1
Locate studs
41 - 61 cm
(16 - 24 in.)
2-2
Mark the wall
2-3
Drill pilot holes
2-4
Tighten lag bolts
[01]
[27]
[25]
8
Wood stud
< 16 mm
(5/8 in.)
[01]
For assistance in determining wall plate location, see Height
Finder at sanus.com.
Verify the center of the stud(s) using an awl, a thin nail, or an
edge to edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8
in.)
Minimum wood stud size: common 51 x 108 mm (2 x 4 in.)
(nominal 38 x 89 mm [1.5 x 3.5 in.])
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.), using a
5.5 mm (7/32 in.) diameter drill bit.
89 mm
(3.5 in.)
CAUTION:
Improper use could reduce the holding power
of the lag bolt. To avoid potential injuries or property damage:
DO NOT over-tighten the lag bolts [25].
Tighten the lag bolts [25] only until the washers [27] are
pulled fi rmly against the wall plate [01].
13 mm 5.5mm
(1/2 in.) (7/32 in.)
6901-002114 <03>