hanseatic WQP8-7636Q Gebrauchsanleitung Seite 45

The seals of the door are sensitive to oil and
grease.
Do not apply grease to the door seals.
■
Wipe away grease and oil which has
■
dripped onto the edge of the open dish-
washer door.
The door seals can be damaged by unsuita-
ble cleaning agents.
Do not use harsh, aggressive, sol-
■
vent-based or abrasive cleaners.
The appliance is designed for a water pres-
sure of 0.4 to 10 bar (0.04 to 1.00 MPa, 4 to
100 N/cm²).
If the water pressure is higher than this,
■
install a pressure reducer. If in doubt, en-
quire about the water pressure with the
water supply company.
Never connect the appliance to the wa-
■
ter tap or the mixing arm of a water heat-
er (continuous fl ow heater, pressure-free
boiler etc.).
Ensure that the inlet hose is not kinked
■
and is carefully connected.
Do not cut through the inlet hose. It con-
■
tains electrical components. If the inlet
hose is damaged, have it repaired by a
specialist.
Do not use old or previously installed inlet
■
or outlet hoses.
The outlet hose must be of a minimum di-
■
ameter of 40 mm so that the water can be
pumped away unhindered.
Do not attach the outlet hose yourself,
■
have it installed by a specialist plumber.
Have the outlet hose checked regularly
for damage or kinks.
Page EN-9
Safety