Technical Information - BabyBjorn ACTIVE Anleitung

ENGLISH
Read this manual carefully before use.
REQUIREMENTS
Minimum requirements: 3,5 kg / 8 lb and 53 cm / 21 in
Maximum weight: 12 kg / 26 lb

TECHNICAL INFORMATION

Material: 60% cotton, 40% Polyester
Lining: 100% cotton
PARTS OF THE BABYBJÖRN BABY CARRIER ACTIVE
Please refer to this diagram when reading the instructions.
STRAPS SEEN FROM BEHIND
A. Straps
B. Strap for lumbar support
C. Lumbar support
D. Sliding buckle clip
E. Head support knob
F. Strap buckle
G. Sliding lumbar support buckle
H. Side latch groove
FOR USE WITH NEWBORN BABIES
.
Start by pulling the straps into their fully extended position. Put on the straps, place the lumbar support
in the lumbar region with the two sliding buckle clips pointing downwards.
. Adjust the position of the sliding buckle to your child's height. Follow the directions on the adjustment label
to ensure that the child is safe and comfortable in the carrier.
. Fasten the carrier's front piece to the straps by inserting the straps' sliding buckle clips into the sliding
buckle on the front piece.
. Adjust the straps and lumbar support so that the latter is in the designated position and all the settings feel
comfortable. Adjust the straps on the lumbar support by pulling them downwards and forwards at a slight
angle. (These are the straps with the horizontal edge found at the lower edge of the carrier.) USEFUL TIP!
It is important to adjust the lumbar support straps first to ensure that the baby carrier is comfortable.
. Adjust the straps so that the baby carrier is comfortable. Wear it close to your body (see diagram).
(These are the straps with the triangular edge found above the lower back support straps.)
. Insert one of the color-coded side latches on the front piece into the side latch groove of the same color on the
straps until it clicks. USEFUL TIP! If you angle the side latch slightly, it is easier to fit it into the side latch groove.
. Now place your child in the baby carrier via the side that is open, with the child's face towards you.
HOLD YOUR CHILD SECURELY UNTIL THE FRONT PIECE IS FULLY AND CORRECTLY FASTENED TO THE
STRAPS. CHECK THAT THE CHILD HAS ONE LEG ON EITHER SIDE AND ONE ARM IN EACH ARMHOLE.
Fasten the second color-coded side latch to the straps (see above, point 6).
IMPORTANT!
Keep it for future reference.
FRONT PIECE SEEN FROM THE INSIDE
I.
J.
K. Armhole
L. Side latch
M. Sliding buckle
N. Adjustment label
O. Instruction label
WASHING INSTRUCTION
Wash separately
Head support
Head support buckle
3