Technical Information - BabyBjorn Baby Carrier Original Bedienungsanleitung

Read this manual carefully before use.
Requirements
Minimum requirements: 3,5 kg (8 lb) and 53 cm (21")
Maximum weight: 11 kg (25 lb)

Technical information

Material: 100% cotton
Parts of the B
aBy
Please refer to this diagram when reading the instructions.
Front piece
A. Head Support Buckle
B. Armhole
C. Side Latch
D. Leg Strap Button
E. Instruction Label
F. Sliding Buckle
G. Adjustment Label
H. Strap Adjuster
I. Head Support Strap
For use with an infant
1. Put on Straps with the B
2. The Cross should be at the bottom of the shoulder blades for maximum comfort.
3. Wiggle the Sliding Buckle up to the highest position for infants 21-23.5" (53-60 cm) in length.
4. Attach the Sliding Buckle Clips on the Straps to the Sliding Buckle on the Front Piece.
5. Starting on one side, slide the Side Latch all the way into the Side Latch Groove on the Strap (red
to red, blue to blue) until you hear a click. HELPFUL HINT: Angle the Side Latch some, and it will
easily slide into the Side Latch Groove.
6. Slide your infant into the Baby Carrier on the open side. HOLD YOUR INFANT CLOSELY
UNTIL THE BABY CARRIER IS FULLY ATTACHED. Both arms of the infant must be through
the Armholes for maximum safety and support.
7. Slide the other Side Latch all the way into the Side Latch Groove on the other Strap until you hear
a click.
IMPORTANT!
Keep it for future reference.
B Baby Carrier Original
®
jörn
Straps
J. Cross
K. B
aBy
L. Head Support Knob
M. Side Latch Groove
N. Strap Buckle
O. Fabric Leg Strap
P. Sliding Buckle Clip
B logo on left chest and Sliding Buckle Clips pointing down.
®
aBy jörn
Washing instruction
B logo
®
jörn
3
Wash separately