Bosch FlexiDomeXT+ Installationshandbuch Seite 11

FlexiDome
XT+
Figure 4 Surface mounting - rear connection
Solid surface
(three pre-drilled
8mm holes)
Three screws
(supplied with
camera)
Three screws
(M5, supplied)
Surface mounting
When using the raised mounting box:
• With a side connection, remove the cap covering the side entrance.
With a rear connection, leave the cap in place.
• Attach the conduit to the mounting box.
• Release the two clips at the bottom of the watertight connection
compartment to remove it from the mounting box.
• Open the cover of the watertight compartment in the mounting box by
releasing the 5 clips.
• Run the power and video wires through separate rubber grommets into
the watertight compartment.
• Run the cable from the camera into the watertight compartment
through the supplied grommet.
• Make the connection inside the watertight compartment and clip on
the cover to seal it.
Note
In order to ensure a watertight cable entry, use round cables of between 5
and 6 mm (0.2 - 0.24 inches) for power and video connection. Use some
silicon spray on the cable to help slide the grommets onto it.
Bosch Security Systems | 2008-08 | V1.1
| Installation Manual
Conduit
EN | 11
Wires
Cap
Surface
mounting box
(VDA-455SMB)
Camera unit
and base