Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3-4 Resistance Measurement
è
1. Set the slide switch at "
" position.
è
2. Connect the black test lead to the "COM" terminal, and red lead to the "V
" terminal.
3. Verify that the power to the circuit under test has been switched off. Connect test leads to the circuit to make the
measurement.
è
/
4. The internal sounder will operate if the resistance of the circuit under test is less than 100
MAINTENANCE
# WARNING : TO AVOID ELECTRICAL SHOCK REMOVE TEST LEAD BEFORE OPENING THE COVER.
4-1 General Maintenance
1. Repairs or servicing not covered in this manual should only be performed by qualified personnel.
2. Periodically wipe the case with a damp cloth and detergent, do not use abrasives or solvents.
14
Werbung
Inhaltsverzeichnis
