Iso-Tech ICM35N Bedienungsanleitung Seite 13

3-2 AC Current Measurement
1. Set the slide switch at "A%" position.
2. Open spring-loaded clamp by pressing trigger on left side of meter.
3. Position clamp around wire or conductor and release clamp trigger, make sure that the clamp is entirely closed.
The clamp must be positioned around only one conductor in a circuit. If the clamp is placed around two or more
current-carrying conductors, then the meter may give incorrect readings.
3-3 AC Voltage Measurement
1. Set the slide switch at "V%" position.
2. Connect the black test lead to the "COM" terminal and the red test lead to the "V
to the circuit to make the measurement.
13
è
" terminal. Connect test leads