Panasonic TY-VK55LV1 Montageanweisungen Seite 30

Fitting procedure
7. Mounting and securing to the main unit's installation mount
① Push the lock lever in the direction of the arrow to unlock.
Then pull out the unit mount plate.
② Insert the hexagonal wrench Ⓔ as shown on the diagram below and lock the unit
mount plate so that it does not move.
⑥ Hexagonal wrench holder
③ Attach the hooks of the upper mount
bracket Ⓕ to the upper notches
in the top of the unit mount plate,
insert the hooks of the lower mount
bracket Ⓕ into the lower holes in the
bottom of the unit mount plate, then
lower the main unit straight down.
Note
• Check that the all four hooks are
securely attached.
④ Fasten the main unit and installation
mount using the main unit fixing
screws Ⓓ (one screw on each side).
⑤ Wire the power cord and the cables
of the connected devices.
Note
• Wire the power cord and cables
in such a way that they do not get
caught in the installation mount.
⑥ Pull out the hexagonal wrench Ⓔ and put it into the hexagonal wrench holder so it
does not get lost.
⑦ Push the main unit in.
Note
• When pushing the main unit in, if it touches an adjacent unit, align the units using
the adjustment knobs (see following page) so that it no longer touches. If the unit is
touching an adjacent unit, pushing it in may result in damage.
30
①
Unit mount plate
⑥ Ⓔ Hexagonal wrench
① Unlock
Lock lever
② Ⓔ Hexagonal wrench
Hook Upper notches
Hook Lower holes
④
Ⓓ Main unit fixing
screws
Mount surface