Autoadapt Turny series Installationsanleitung Seite 16

16
Turny Getting seated
Fit seat
Use the two consoles which come with Turny to fit the BEV, Compact or Recaro
seats. Fit as indicated in the illustration below. If Turny is to be combined with
Carony, replace the consoles with roller profiles. Different elevation kits can be
ordered as accessories if needed. To see the range of roller profiles and exten-
sion kits, please visit dealerweb.autoadapt.com.
Fit belt
In order to avoid the risk of the belt injuring the user or being pulled off
!
in a collision, the female connector must be movable and not lie against
the hip. The actual strap of the belt should not be in contact with Turny.
If possible, fit the lower anchor bracket for the belt in the original fasten-
!
ing. If this is not possible, fit to Turny's console.
Always fit the female belt connector to Turny's console.
!
Always try to achieve the following belt geometry. The illustrations below show
the lower anchor bracket for the belt and the female belt connector fitted to
Turny' s console.
Use the hole pattern and dimension of screw
that match the seat in question.
30-80°
Minimum and maximum
height of female belt
connector's top edge.
80-45°