Operation - Hama RC 660 Bedienungsanleitung

4.1. Inserting the batteries
• Open the battery compartment (14),
insert three AAA batteries with the
correct polarity and close the battery
compartment (14).
4.2. Replacing the batteries
• Open the battery compartment (14),
remove and properly dispose of the
dead batteries and insert three new
AAA batteries with the correct polarity.
Replace the battery compartment cover.

5. Operation

Note
• Immediate Hold down the 12/24/
YEAR button (8), HOUR/ MONTH
button (9) or the MIN/ DATE button
(10) to select the values faster.
ly remove and dispose of dead
batteries from the product.
5.1. Automatic date/time setting
using the DCF signal
• Once you have inserted the batteries,
the display is switched on, an acoustic
signal sounds and the alarm clock
automatically starts searching for a DCF
radio signal. During the search, the
radio icon /
can take 3 to 5 minutes.
• When the wireless signal is received,
the date and time are automatically set.
4
will flash. This process
Display
/
Display flashing
Display steady (not
flashing)
Not displayed
• Press and hold the MIN/ DATE button
(10) for approx. 3 seconds to start a
manual search for the DCF radio signal.
Note – Time settings
• If, during initial setup of the device,
no DCF radio signal is received
within the first few minutes, the
search is aborted. The radio icon
will go out.
• If there are reception problems, we
recommend leaving the clock to
sit overnight, since interference is
generally less at night.
• In the meantime, you can start a
manual search for the DCF radio
signal at another location or you can
manually set the time and date.
• The clock automatically continues to
search for the DCF signal every hour.
If the signal is received successfully,
the manually set time and date are
overwritten.
Searching for the
DCF signal
Active
Successful – signal is
being received
Inactive – no signal
reception