Maintenance; Firmware Updating; Fuses Replacement; Cleaning - Videotec ULISSE COMPACT HD Bedienungsanleitung

12 Maintenance

CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.

12.1 Firmware updating

The H.264 encoder firmware can be
upgraded directly from the web interface.
If necessary it is possible to update the device
firmware.
For further information please contact the VIDEOTEC
service center.
The firmware updating operation can be done on
site, using the cable supplied with the pan & tilt. The
operation can also be done in remote mode (only
VIDEOTEC MACRO and PELCO D protocols) using an
USB/485 Serial converter (not supplied).

12.2 Fuses replacement

CAUTION! For continued protection against
risk of fire, replace only with same type and
rating of fuse. Fuses must be replaced only
by service personnel.
Fig. 61
34
The used fuses are described below.
FUSES REPLACEMENT
Voltage Fuse F1
24Vac, 50/60Hz T 4A L 250V 5x20
120Vac, 50/60Hz T 4A L 250V 5x20
230Vac, 50/60Hz T 4A L 250V 5x20
Tab. 8
As an alternative, use approved fuses featuring the
same characteristics.

13 Cleaning

13.1 Cleaning the window and
plastic parts
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
glasses lenses.
Fuse F2
T 6.3A H 250V 5x20
T 4A H 250V 5x20
T 2A H 250V 5x20
MNVCUCHD_1801_EN