Connecting The Cd-Rw Drive To Your Computer - IBM 22P4800 Bedienungsanleitung

2. Select the USB 2.0 Portable CD-RW drive. (For example, select e, where e
represents the drive letter of the CD-RW drive.
3. Click Properties -> Hardware -> IBM CD-RW USB 2.0 USB Device.
4. Click Properites and then select the Properties tab.
5. Select Enable digital CD audio for this CD-ROM device.
6. Click OK.
9 Emergency eject lever
When ejecting the media with the power off, insert a thin metal rod such as a
paper clip into the emergency eject lever and slide it in the direction of the
arrow shown.

Connecting the CD-RW drive to your computer

This section provides information to connect the IBM USB 2.0 Portable CD-RW
Drive to your computer.
Follow these instructions to connect the CD-RW drive:
1. Locate the USB cable included with this option. One connector on the USB
cable is smaller than the other and has two small buttons on each side.
2. Squeeze the two buttons on the smaller connector and attach that end of
the USB cable to the USB connector on the back of the CD-RW drive.
1-6
IBM USB 2.0 Portable CD-RW Drive: User's Guide