Maintenance; Spare Parts; Troubleshooting; Warranty - Wolf Garten LI-ION POWER FINESSE 50 R Originalbetriebsanleitung

Maintenance

Storage
B
z Make sure to store the battery-powered shears out of the reach
of children.
z Always attach the blade guard for transport and storage.
z Always recharge the lithium-ion battery prior to any prolonged
period of non-use, i.e. before storing the shears away in winter.
z Store the battery-powered shears in a dry and frost-free location.
z When storing the tool in the storage box for an extended period
(e.g. in the winter), disconnect it from
well as the plug adapter (1) and store the power supply unit and
any other accessories in their designated locations.
z Attach the cover to protect the battery-powered shears including
accessories.
General instructions
D
1
Caution! Counterrotating blade
Before carrying out any maintenance or cleaning work:
z Never actuate the switches
z Do not touch the moving blade.

Spare parts

Order no. Item designation
7266 090 F 50 TS
7266 095 Accu 50 EM R
7267 095 Accu 50 EM C
7268 095 Accu 50 EM B
7266 077

Troubleshooting

Problem: Possible causes:
•
Blades run hot
•
•
Motor fails to start
•
Problems when
•
charging the battery
Jerky run, machine
•
heavily vibrating
If in doubt, bring your tool to a WOLF-Garten service workshop.
1
Switch off the battery-powered shears before examining them or working on the blade.

Warranty

The warranty rules issued by our company or the importer apply to
every country. As part of the warranty, we remedy malfunctions on
your appliance free of charge provided that this malfunction is
caused by a material or manufacturing defect. In the event of a
warranty claim, please turn to your dealer or the nearest branch
office.
14
B the power supply (2) as
D (1) (2).
Description
Telescopic handle with carriage - infinitely height adjustable between 85 and 120 cm
Replacement blade for FINESSE 50 R / cutting width 80 mm
Replacement blade for FINESSE 50 C / cutting width 60 mm
Replacement blade for FINESSE 50 B / cutting width 110 mm
UK charger
Blade is blunt
too much friction due to insufficient lubrication
Battery flat
Battery defective
Battery or charger defective
Blade damaged
Cleaning
z Clean the battery-powered shears after every use with a dry
cloth. If necessary, use a brush to remove persistent dirt.
z Clean and lubricate the gearbox at the end of the gardening
season (see "Cleaning or replacing the blade").
z Never clean the battery-powered shears with a water jet.
Cleaning or replacing the blade
E F G H
3
Blunt blades should not be resharpened but replaced.
1. Lift the locking mechanism
to the back (2).
2. Remove the blade from the battery-powered shears.
3. Grease the plastic ring of the blade
4. Clean the visible part of the gearbox and lubricate it with grease
if necessary.
5. Fix the blades in place on the gearbox cover
6. Slide the sliding shoe over the battery-powered shears until the
locking mechanism engages
into the gearbox).
Remedy:
• Replacing the blade
• Use petroleum jelly to grease the plastic ring of the
blades
• Recharge battery
• Take the unit to the WOLF-Garten service workshop
• Take the unit to the WOLF-Garten service workshop
• Replacing the blade
E (1) and pull the sliding shoe away
F using petroleum jelly.
.
G
(blade will automatically snap
H
G