Technical Data; Maintenance - Lelit PG018NEUTRO Handbuch

COMPONENTS
A Safety cap
B1 On/off boiler switch
B2 Boiler switch 2
C Steam switch
D Steam hose socket connection
E Low water red indicator light
G Power cord with plug
H Steam regulator knob
M Pressure gauge
USER INSTRUCTIONS:
Remove the machine from its packing and make sure all the packing parts have been taken off (including
1.
the protection bags).
Lay the machine on a flat and steady surface fitted to support next to a wall socket (max. Mt. 1,5).
2.
3. Unscrew the safety cap (A) and fill the tank with max 5,0 litre water through the supplied funnel and make
sure that the water does not overspill. Screw the cap (A) by pressing it down slightly.
4. Connect the plug to the main supply point
5. Push the boiler switches (B1) + (B2) which will come on when the machine is plugged in.
6. Wait until the boiler switches (B1) + (B2) go off. The steam is ready and the gauge (M) displays the
pressure level (max about 4 - 4,7 bar)
7. Insert the steam hose plug (GV520) into its proper socket (D); push the plug into the socket until it clicks.
The steam hose is supplied with a handle to attach an accessory. After attaching one of the brushes or an
accessory onto the handle. Attention: make sure that it was correctly attached (risk of scalds)
8. Regulate the steam through the steam knob (H). The steam shall flow out by pressing the steam switch (C)
first, which will come on, then the button (0-1) in the inside of the steam hose handle (GV520). You may
get the best performance by spraying the steam on a cloth until the steam flows uniformly.
9. Remove the brush/accessory by pushing the red button and take it off. Attention: before taking the
brush/accessory off make sure that the steam switch (C) is off.
10. When the water tank is almost empty, the indicator light (E) will glow. Before filling the tank again, make
sure that there is no flow of steam from the brush and the plug (E) is disconnected
11. At the first request of steam, after switching it on, there might be a drop of pressure caused by the internal
hoses' filling. Wait for some minutes that the switches (B1 and B2) are off.

TECHNICAL DATA:

Boiler power: 2*1000 watt
Working pressure: 4.5 bar
Max. pressure: 5.5 bar
Tank capacity: 6,0 litres
CAUTION
Never leave the machine unattended when it is plugged in
-
Before filling the tank disconnect the plug from the main supply point.
-
Never remove the safety cap while the machine is running.
-
Make sure there is no emission of steam coming out of the brush before removing the cap.
-
The machine is supplied with a thermal-stop device which must only be replaced by authorized technicians
-
(our Service Shops).
Replace the safety cap with original spare parts only.
-
In case of repairs contact our Service Shops.
-

MAINTENANCE:

Use of tap water only .
Clean the tank periodically (each 15-20 litre water) by rinsing it with tap water.
CAUTION:
In case you have to wash leather, any particular garments or wooden surfaces, please read the manufacturer's
instruction booklet carefully and make a test on a hidden part before using the machine.
Pag. 4
English