Telcoma Automations K100 Installationsanweisungen Seite 28

INSTRUCTIONS FOR INSTALLING THE ELECTRONIC CONTROL UNIT K 100
GB
Please read these instructions carefully before installing the control unit.
Improper use or a connection error could jeopardise correct operation of the product and endanger
the end user.
DESCRIPTION OF PARTS in Fig. 1
1) PP Impulse Button.
2) STOP/PROG button for Programming and Stop *.
3) Built-in radio card.
4) Functions dip-switch .
5) Trimmer for motor power adjustment.
6) Jumper Jp1 (bypass of motor power adjustment
and soft-start).
7) 24 V low voltage connection terminal board.
8) Reset control box. Momentarily short circuiting
the two pins is the same as interrupting and
restoring voltage.
9) Signalling LED for terminal board inputs. LED
on = input closed.
10) LED Programming (L1).
11) 230 V connection terminal board.
* This STOP button is not a safety button but serves solely to facilitate tests during installation.
MODELS
Description of K100 control unit models:
K100 control unit for gate automation with 1 motor, incorporated TANGO range receiver
K100 SW control unit for gate automation with 1 motor, incorporated TANGO SW range receiver
The control units are equipped with:
- electronic torque regulation
- motor slowdown
- motor brake
- Triac test (motor control self-diagnosis)
- anti-crushing system (optional MAS 100)
Important notes:
The K100 control unit is unsuitable for controlling motors with condenser and limit switch already wired
directly inside the actual motor (e.g. motors for roller shutters).
Do not use the slowing down function with hydraulic motors.
The gate must always be fitted with mechanical stops.
28
12) 6,3 A line fuse.
13) Motor and condenser connection terminal
board.
14) Primary transformer connection terminal board.
15) Optional anti-crushing card (MAS 100).
16) 24 V 0,3 A fuse.
17) Secondary transformer connection terminal board.
18) Limit switch connection terminal board.
19) Trimmer for adjustment of slowdown time (only
on some versions).