Selecting A Paper Type - Citizen CT-S4500 Benutzerhandbuch

3.14 Selecting a Paper Type

Paper type selection is available by the combination of memory switches MSW4-4
and MSW4-5 by the used of "Memory Switch Select Mode". In addtion, the following
procedure is available.
1. Enter Selecting Paper Type mode.
1) With the top cover open, turn on the printer power switch while pressing and holding the
FEED key.
The buzzer sounds and the status LED flashes in green.
2) Remove your finger from the FEED key briefly, and then press the FEED key three times in
succession.
Next, closing the top cover causes the buzzer to sound briefly three times. The type of
paper currently selected is represented by the status display LEDs.
2. Select Paper Type.
Press the FEED key to match the paper used with the paper type displayed by the status
display LED.
(Refer to the table below.)
Label media
Thermal roll paper
Black mark paper
3. Save the selected Paper Type to the Printer.
Open the top cover and then close it as it is.
The paper type selected is stored in the printer memory switch as shown in the table below.
The paper type setting mode finishes and the printer restarts automatically.
Paper type
Thermal roll paper
Black mark paper
Label media
Paper
Press the FEED key ↓
Press the FEED key ↓
Returns to label paper selection.
Black mark paper/label media
Black mark paper/label media
4-4
Thermal roll paper
60
— —
Status LED
Green
Amber
Red
MSW
4-5
-
Black mark detection
Label gap detection