Ethernet (Lan)/Wireless Lan Interface Board - Citizen CT-S4500 Benutzerhandbuch

3.6 Ethernet (LAN)/Wireless LAN Interface Board

This section provides an overview of the interface board. For details on this board, in-
cluding explanations about the USB host function and XML peripheral device support,
refer to the separate manual.
Connecting the Interface Cable
1. Turn off the power.
2. Confirm the orientation of the interface cable and connect it to the port.
3. Connect the other connector to a hub, router, or similar device.
CAUTION
 When disconnecting the cable, always hold the connector.
 Place the interface cable so that people do not trip on it.
 Do not connect multiple interfaces at the same time.
 Hold the connector of the LAN cable perpendicular and straight when connecting or discon-
necting it. Doing it at an angle may cause the connector to misconnect.
Connecting a Peripheral Device
1. Turn off the power.
2. Connect the cable of a peripheral device to this port.
CAUTION
A peripheral device cannot be controlled if it is connected to the USB power supply port.
Be sure to connect it to the USB port of the interface board.
39
— —