Maintenance; After-Sales Service - S&P EB-Series Handbuch

level in the room is higher than the level selected with the potentiometer.
Likewise, the extractor will stop automatically when the humidity level drops
below the selected level.
The diagram on fi g.7 shows how to connect the unit through an independent
switch.
The diagram on fi g.8 shows how to connect the unit through the light switch.
EB MODELS HT (12V~50Hz)
For these models use the CT-45/12 safety isolating transformer:
Fig. 13: To switch the transformer and the extractor through an independent
switch.
Fig. 14: Switching the transformer and the extractor through the light switch.

MAINTENANCE

IMPORTANT: Before manipulating the ventilator, make sure it is disconnected
from the mains supply even if it has previously been switched off. Prevent the
possibility of anyone else connecting it while it is being manipulated. The ex-
tractor needs only a periodical cleaning using a cloth lightly impregnated with
a soft detergent.
AFTER SALES SERVICE
The extensive network of S&P Offi cial Services guarantees good technical as-
sistance all over Spain. If you observe any anomalies in the convector, please
contact any of the above mentioned Services, where you can get the correct
advice. Any modifi cation that is not strictly necessary for the installation of the
device and carried out by persons outside of the S&P Offi cial Services will inva-
lidate the guarantee.
For any queries regarding the S&P Products go to the S&P After Sales Service
network if is Spanish territory or your dealer in the world. For the nearest loca-
tion you can consult the webpage: www.solerpalau.com.
18