User Instruction; After-Sales Service; Cleaning And Maintenance - S&P DECOR-100 DESIGN Bedienungsanleitung

The timer is set by the adjuster "t min.":
• To reduce the run-on time, turn anti-
clockwise (min. 2 minutes)
EN
• To increase the run-on time, turn cloc-
kwise (max: 20 minutes).
ATTENTION: When the fan is on run-on
time phase, you must let it finish before
a new setting.
Note:
If the fan never turns on.
• Humidity adjuster is not at its lowest
setting. Turn anticlockwise the adjuster
(do not force the adjuster) to the mini-
mum setting.
• The fan is fitted in an area where there
is no air flow.
• The humidity level in the room is below
60% RH
If the fan never stops:
• Humidity adjuster is not at its highest
setting. Turn clockwise the adjuster (do
not force the adjuster) to the maximum
setting.
• The humidity level in the room is above
90% RH

USER INSTRUCTION

This instruction manual is available un-
der http://www.solerpalau.com or con-
tact your National Soler & Palau contact.
List in http://www.solerpalau.com.

CLEANING AND MAINTENANCE

Important: disconnect from the mains
supply before carrying out cleaning or
maintenance
18
The Fan needs only a periodical cleaning,
using a cloth lightly impregnated with a
soft detergent.
AFTER SALES SERVICE
We recommend you not to try to disman-
tle or remove any other parts than those
mentioned as any tampering would au-
tomatically cancel the S&P guarantee.
If you detect any fault, contact your S&P
dealer.
PUTTING OUT OF SERVICE AND
RECYCLING
EEC legislation and our con-
sideration of future gener-
ations mean that we should
always
where possible; please do
not forget to deposit all pack-
aging in the appropriate recycling bins. If
your device is also labeled with this sym-
bol, please take it to the nearest Waste
Management Plant at the end of its ser-
vicable life.
S&P reserves the right to alter specifica-
tions without notice.
recycle materials