Lacor COMPACT Gebrauchs- Und Instandhaltungsanleitung Seite 33

1.- Take off the wrapping before using the electrical appliance. Do not throw away the wrapping
until you have checked that the appliance functions properly.
2.- Make sure you place the machine onto a flat, hard surface. Avoid contact with excessively
warm areas. Check that the connecting wire and the power point are in perfect condition.
3.- This machine was designed to vacuum-pack solid, dry products. DO NOT USE IT WITH
LIQUIDS OR SAUCES. They may permanently damage the suction pump. If you wish to
pack sauces, freeze them first and, when they are completely hardened, vacuum-pack them.
4.- The bag is sealed using heat, so the necessary safety measures must be followed to avoid
personal injuries.
5.- The bags/reels supplied have been specially manufactured for use with food products. The
heat supplied during the sealing operation was established according to the thickness and
quality of the bags/reels supplied, so the appliance may not work with bags/reels supplied by
other manufacturers.
6.- Do not leave the machine functioning when empty. Prolonged uses can have a negative
effect on the suction pump's lifespan. If the motor overheats, switch it off immediately and
wait for it to cool before using it again.
7.- Before starting to use the machine, have all the required materials like food products,
vegetables, etc. at hand, as well as scissors, if necessary.
8.- If a plastic reel is used for packing, proceed as follows;
a.- Select the desired length and cut with the scissors as straight as possible.
b.- Place one of the open sides inside the machine to proceed to seal.
c.- Close the lid and, when the motor starts, press SEAL. The blue indicator will begin to
flash. Keep the lid pressed down until the cycle ends and the indicator light turns off.
d.- To open the lid, press the AIR RELEASE button and the air that creates the vacuum and
prevents you from opening the lid will be released. Remove the bag and check it is
properly sealed and there are no bubbles and imperfections.
e.- Now proceed as though it were a bag.
9.- If plastic bags are used for packing, proceed as follows:
a.- Put the product inside the bag and make sure it is in dry conditions.
b.- Place the open side of the bag inside the machine between the suction nozzle and the
lower vacuum pad.
c.- Close the lid and, when the motor starts, the blue indicator will turn on
d.- Once a vacuum has been obtained inside the bag, the sealing process will begin
automatically. Keep the lid pressed down until the cycle ends and the indicator light turns
off.
e.- To open the lid, press the AIR RELEASE button and the air that creates the vacuum and
prevents you from opening the lid will be released. Remove the bag and check it is
properly sealed and there are no bubbles and imperfections.
33