Assembly Diagram - Palazzetti ECOMONOBLOCCO WT F Serie Einbauhandbuch

5.4

Assembly diagram

In Fig. 5.4 shows by way of example one assembly
diagram.
A) Seal the chimney flue and check that it has its own
earthing in compliance with current regulations.
B) External air intake (under fire plane)
C) Heat recovery grill with minimum section 1263 cm
D) Fireproof hood and load-bearing structure.
E) Covering in ceramic fibre or in rock wool with external
aluminium foil.
F) Shield the wooden parts with flame retardant material.
If the appliance is installed on a flue that had previously
been used by other fireplaces, it is necessary to perform
thorough cleaning to avoid anomalous operations and to
prevent the possible burning of unburnt substances that
are deposited on the internal walls of the same.
Incorrect installation can compromise the safety of the
appliance.
The cladding must be made of fireproof material.
5.5 Earthing
The appliance is provided with screw for equipotential
coupler that can receive a cable with cross-section
from 2.5 mm to 6 mm
2
equipotential bonding of the earth in accordance with the
rules in force. This coupling is located in the back of the
fireplace and indicated with the symbol
* For Italy, these technicians must be in possession of
the letter "C" issued by the Chamber of Commerce on
the basis of Italian Ministerial Decree 37/08.
30
, that can be used to obtain the
2
(Fig. 5.5)
Fig. 5.4
.
2
C
D
Fig. 5.5
Product images are purely indicative
cod. 004777520 - 21/03/2019 - Palazzetti - PN - Italy
E
A
B
F