Introduction - Swim & Fun Inverter PRO series Handbuch

UK
1.

Introduction

Thank you for having chosen a Swim & Fun heat pump to heat your water. The heat pump
will heat the bathing water and keep it at a constant temperature, when the ambient air tem-
perature is between -12°C and +40°C. The heat pump can only be used outdoors.
This manual contains all the necessary information concerning installation, troubleshooting, disas-
sembly and maintenance. Read the instructions carefully before you open, use and maintain the
device. Failure to comply with these instructions will void the warranty. The manufacturer of this
product will not be held responsible if someone comes to harm, or the unit is damaged as a result
of faulty installation, troubleshooting or unnecessary maintenance.
This heat pump is designed for the heating of swimming pools, and has the following characteris-
tics:
1. Durability
The heat exchanger is made of PVC and titanium pipes, which can withstand prolonged exposure
to pool water.
2. Flexible installation
All our heat pumps has been fully tested and are ready for use when they leave the factory. The
heat pump must be installed by a qualified installer.
3. Quiet operation
The device has an efficient compressor and a low noise ventilation motor, which guarantees quiet
operation.
4. Easy handling
The digital control panel allows easy setting of the desired temperature.
MV-1225-1225-1298-11-2018 . © All rights reserved Swim & Fun Scandinavia ApS
1. Introduction .................................................................... 93
2. Technical specifications ................................................. 94
3. Safety warnings and notices .......................................... 95
4. Installation guide ............................................................ 95
4.1. Locating the heat pump ....................................... 96
4.2. Other instructions ................................................ 96
4.3. Installation illustrations ........................................ 97
4.4. Connecting hoses/pipes ...................................... 98
4.5 The fitting of accessories ..................................... 98
5. Initial operation .............................................................. 99
5.1. Flow Switch ......................................................... 99
5.2. Time delay ........................................................... 99
5.3. Condensation .................................................... 100
5.4. Pressure gauge display ..................................... 100
6. Initial startup ................................................................ 100
7. Instructions for use ...................................................... 101
8. Maintenance ................................................................ 103
9. Winter preparation ....................................................... 103
10. Warranty ...................................................................... 104
11. Troubleshooting ........................................................... 105
12. Introduction of the bottled gas regulation .....................111
93