Installation; Unpacking; Location; Operation - Hatco GRSR Serie Installations- Und Bedienungsanleitung

INSTALLATION

UNPACKING

The Round Heated Shelves are shipped with most
components pre-assembled and ready for operation. Care
should be taken when unpacking shipping carton to avoid
damage to unit and components enclosed.
WARNING
To prevent any injury or damage to the unit do not pull unit
by power cord.
WARNING
To prevent any injury, discontinue use if power cord is
frayed or worn.
1. Remove unit from box.
2. Remove information packet.
3. Turn unit upright and position warmer in desired location.
4. Remove protective paper from all surfaces before placing
into service.
NOTE: If installing as a drop-in unit, refer to SPECIFICATIONS
for countertop opening dimensions.

OPERATION

WARNING
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
1. Plug unit into an electrical outlet of the correct voltage, size
and plug configuration. See SPECIFICATIONS for details.
2. Turn the power switch
See Figure 5 . Indicator light will turn on when unit is
energized.
3. Allow unit 15-20 minutes to reach operating temperature.
Form No. GRSRCEM-0408
to the ON position.

LOCATION

NOTE: Unit must be transported in the upright position.
For proper operation and maximum performance, locate the
Round Heated Shelf in an area where the ambient air
temperature is constant and is a minimum of 70°F (21°C).
Areas which are susceptible to active air movements or
currents should be avoided, i.e., near exhaust fans or hoods
and air conditioning ducts.
Unit is not weatherproof. For safe and proper operation
the unit must be located indoors where the ambient air
temperature is a minimum of 70°F (21°C) and a maximum
of 85°F (29°C).
For safe and proper
be located a reasonable distance from combustible walls
and materials. If safe distances are not maintained,
discoloration or combustion could occur.
To avoid any injury or damage locate the unit at the proper
counter height, in an area that is convenient for use. The
location should be level to prevent the unit or its contents
from accidentally falling, and strong enough to support
the weight of the unit and food.
NOTE: Units are supplied from the factory with temperature
control thermostat set on high. If temperature needs to be
adjusted lower, carefully remove hole plug and turn thermostat
adjustment screw counterclockwise until desired operating
temperature is reached. See Figure 5 .
6
CAUTION
WARNING
operation, the unit
CAUTION
must