Teka DP-90 Bedienungsanleitung Seite 11

Index
Description of the appliance
Instructions for use
Cleaning and maintenance
Problem solving
Sizes and specifications
Accessories supplied
Installation
Active charcoal filters
Description of the appliance
A An electronic programmer device with
TOUCH CONTROL technology to
control speed, light, programming and
power indicators in use as well as filter
saturation.
B Metal filters.
C Lamps - 20 W (G-4).
D, E Vertically adjustable tubecovers.
F Remote control.
You may control the kitchen hood by operating the
Page
controls as shown in the diagram.
11
11
12
12
12
13
13
13
Switch on the extractor fan a few minutes before
you start to cook in order to ensure that a steady air
flow has been established before fumes appear.
Allow the extractor fan to run for several minutes
after you have finished cooking (between 3 to 5
minutes) in order to expel all the grease from the
outlet duct. This prevents the return of grease,
smoke and smells.
Proceed as follows:
1) Turn the kitchen hood on and choose the
required speed.
2) Press "timer". The "Program DISPLAY" will flash.
3) Select the required time by pressing the increase
and decrease speed selectors. There is a
variation of 5 in 5 minutes. (Min.= 5 min.; Max.=
45 min.).
4) Once the required time has been selected, press
"timer" again to memorise the program.
5) The kitchen hood will turn itself off once the
programed time has finished.
The intensive speed "H" can only be selected
manually
approximately 10 minutes.
Filter saturation indicators
Clean the filters when the saturation indicator lights
up. (See page 12, Filter cleaning section).
Once you have cleaned the filters, and with the
hood turned off, press the increase and decrease
speed buttons at the same time for 3 seconds and
the indicator will switch itself off.
Instructions for use
Programming timer
and will change to speed 2 after
11