Before Training - Pettec Trainer Advance 2.0 Handbuch

How to pair remote control and trainer
If your trainer does not beep when the TONE button of the remote control is pushed, or
if you feel the trainer is not responding to the remote control, follow these steps to pair:
1. With the trainer off your pet, turn the trainer off. Restart, press and hold the On/Off
button until the green LED light flashes every second on the trainer. This continues for
16 seconds, within which pairing should be completed.
2. Press and hold the TONE and VIBRA button of the remote control at the same time
until the green LED light on the trainer flashes rapidly for 5 times, indicating pairing
is completed.
Pairing second trainer
1. Set the toggle switch to 2.
2. Turn on the trainer of dog 2, press any mode buttons to verify function.
3. If dog 2 trainer does not respond, pairing may be needed. Repeat steps in How to
pair remote control and trainer.
30
PROPER DOG TRAINING
Proper training is the key to a harmonious coexistence between dog and man. But dog ow-
ners often reach the limits of their abilities when training their four-legged friends. The
Remote Vibra Trainer Advance 2.0 is a gentle dog-training aid which helps to effectively
discourage your pet from undesirable behaviors.
With the Remote Vibra Trainer Advance 2.0 you can intervene directly, even from a dis-
tance, to immediately react to bad habits. Most dogs permanently adjust their behavior
after just one or two uses of the Trainer. Please note that the Trainer is a training device
and not a toy, and always should be used with care. So at this point we ask you to observe
the following guidelines:

Before Training

1. Be sure that your dog's undesirable behavior is not a result of insufficient physical
activity or health problems. In this case please do not use the Trainer, and seek pro-
fessional advice.
2. Get your dog accustomed to the Trainer collar before you turn it on.
3. For safety, do not alow your dog to swim while wearing the Trainer. The collar's weight
or vibration could hinder your dog's ability to swim. If the Trainer gets wet, simply let it
dry. After exposure to water, never open the rubber cover to the charging connector,
to prevent moisture from getting into the Trainer.
During Training
1. Immediately remove the Trainer if your dog appears agitated!
2. Always use the Trainer in a controlled manner. Just as with normal training, it helps
to give clear commands. Your dog must first learn these to be able to react approp-
riately to them.
3. Train your dog for a maximum of 1-2 hours per day. Remove the Trainer after each
training session and turn it off.
4. Always reward your dog after a successful traning session.
31