Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
How the remote control buttons work
1
Dog toggle switch (1 / 2)
Located on the upper left face of the remote control is a toggle switch, allowing
switch between Dog 1 and Dog 2.
Tone only button (TONE)
2
Sends an audible tone to the trainer. No vibration is delivered.
Vibration only button (VIBRA)
3
Delivers vibration through the Contact Area on the remote control at the level
shown on the digital display. When held down for ten consecutive seconds, the
trainer will "time-out", and vibration cannot be delivered for five seconds. You must
release and press the button again after the five second time-out period, before
additional vibration can be delivered.
4
Vibra Up Button (
): Increase vibration intensity by 1.
Vibra Down Button (
): Decrease vibration intensity by 1.
Vibration/sound signal button (DUAL)
5
Pressing this key transmits both a vibration and a sound signal at the same time.
PetTec-Tipp:
To connect a second trainer, please set the toggle switch to 2 and switch on the trainer to
be connected. The new trainer connects to the remote control by simultaneously pressing
the tone signal and vibration buttons. Read more on page 30.
22
1
4
2
3
5
23
Werbung
Inhaltsverzeichnis
