Lincoln Electric LINC FEED 33S Bedienungsanleitung Seite 8

6. Quick Connect Couplings (For water cooled model
only): For connecting water cooled torches.
Warm water from torch.
Cool water to torch.
7. Digital Display A: It shows the actual welding
current value (in A), and after finishing welding
process, it shows the average value of the welding
current.
8. Digital Display V: It shows the actual value of
welding voltage (in V), and after finishing welding
process, it shows the average value of welding
voltage.
9. Fast-Mate Adapter: For connecting electrode touch.
10. Quick Connect Couplings: If water cooled torches
are used, connect water lines from water cooler
here. Refer to torch and water cooler guidelines for
recommended cooling liquid and flow rates.
11. Fast-Mate Adapter: Input power connection.
12. Gas Connector: Connection for gas line.
13. Amphenol Connection: 8-Pin connection to power
source.
14 14
19 19
14. Torch Mode Switch: It enables selection of 2-step
or 4-step torch mode. The functionality of 2T/4T
mode is shown in the picture below:
13
12
11
10
15 15 18 18 16 16 17 17
20 20
↑
Trigger pressed
↓
Trigger released
A. Welding Current.
B. Burnback time.
C. WFS.
G. Gas.
15. Cold Inch / Gas Purge Switch: This switch enables
wire feeding or gas flow without turning on output
voltage.
16. Pre-welding wire speed control knob: Enables
change of the wire feed speed before starting
welding process in a range from 1,0 [m/min] to the
value which was set by WFS knob [2].
17. Burnback Time Control Knob: It enables to obtain
the desired length of electrode wire, which protrudes
from the tip of the torch after ending welding;
adjusting range from 20 to 320ms.
18. Gas Flow Regulator: Regulate flow between 0-25
LPM (liter/min.).
19. Wire Drive: 4-Roll wire drive compatible with 37mm
drive rolls.
20. Wire Spool Support: Maximum 5kg spools.
Accepts plastic, steel and fiber spools onto 51mm
spindle.
The Linc Feed wire feeders must be used with the door
completely closed during welding.
Loading the Electrode Wire
Open the side cover of the machine.
Unscrew the fastening cap of the sleeve.
Load the spool with the wire on the sleeve such that the
spool turns clockwise when the wire is fed into the wire
feeder.
Make sure that the spool locating pin goes into the fitting
hole on the spool.
Screw in the fastening cap of the sleeve.
Put on the wire roll using the correct groove
corresponding to the wire diameter.
A-3
WARNING