Technical Data - Zanussi THE 4750 Benutzerinformation

Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis of:
elapsing time
type, volume and dampness of laundry.
5)
on the LCD
Programme in-
Full water reservoir.
active
Drying cycle to Small laundry volume./Too dry laundry for
short selected programme.
Fluff filters clogged.
To high loading volume.
Drying cycle to
Laundry insufficiently spun.
6)
long
Particularly high room temperature - no ma-
chine fault.
1) In case of error message on the LCD (e.g. E51- only dryers with the LCD): Switch the dryer off and on. Set
programme. Press the START PAUSE button. Does not work? - inform local service and quote the error
code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaningchapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).

Technical data

height x width x depth
drum volume
depth with the load door opened
adjustable height
the appliance weight
maximum load volume
voltage
necessary fuse
total power
energy efficiency class
energy consumption kWh/cycle
annual energy consumption
type of use
62
1)
Turn it to DRUM LIGHT (if available) or to
any programme.
Replace light bulb (see next section).
Automatic process; this is not a machine
fault.
Empty water reservoir
PAUSE button.
Select time programme or higher drying lev-
el (e.g. EXTRA DRY ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
50,5 kg
7 kg
220-230 V
6
1050
A
2,35 kWh
159,9 kWh
Domestic
3)
, press START
www.zanussi.com