For Customers In Europe And United Arab Emirates - Sony JIG-ST9_NT3 Bedienungsanleitung

WARNING
Do not install the appliance in a
confined space, such as a bookcase or
built-in cabinet.
To reduce the risk of fire, do not cover
the ventilation opening of the appliance
with newspapers, tablecloths, curtains,
etc.
Do not expose the appliance to naked
flame sources (for example, lighted
candles).
To reduce the risk of fire or electric
shock, do not expose this appliance to
dripping or splashing, and do not place
objects filled with liquids, such as vases,
on the appliance.
To prevent injury, this apparatus must
be securely placed on the cabinet in
accordance with the installation
instructions.
When unpacking or handling the
system, be sure to handle the system
with two or more persons. Dropping the
system may cause personal injury
and/or property damage.
Indoor use only.
On power sources

The unit is not disconnected from the
mains as long as it is connected to the
AC outlet, even if the unit itself has
been turned off.

As the main plug is used to disconnect
the unit from the mains, connect the
unit to an easily accessible AC outlet.
Should you notice an abnormality in
the unit, disconnect the main plug
from the AC outlet immediately.
Recommended cables
Properly shielded and grounded cables
and connectors must be used for
connection to host computers and/or
peripherals.
2
GB
CAUTION
The use of optical instruments with this
product will increase eye hazard.
As the laser beam used in this Home
Theatre System is harmful to eyes, do
not attempt to disassemble the cabinet.
Refer servicing to qualified personnel
only.
Pick-up unit of this appliance is
classified as a CLASS 3R LASER product.
Visible and invisible laser radiation is
emitted when the laser protective
housing is opened, so be sure to avoid
direct eye exposure.
This marking is located on the laser
protective housing inside the enclosure
of the player in the Bar stand.
For customers in Europe and
United Arab Emirates
This appliance is classified as a CLASS 1
LASER product by IEC60825-1:2007. This
marking is located on the rear exterior of
the Bar stand.